Is her skate shop closed? Learn exactly how to change or use a brand-new grip ice cream on a skateboard deck in less than 10 minutes v this DIY tutorial.

You are watching: How to put on grip tape

Need to download a brand-new grip ice cream on her favorite four-wheel plank? room you one of those who constantly grips his or her very own board?

Find a comfortable bench or chair come sit on and also get prepared to carry out it.

The an initial thing you need to do is to take it the trucks and also hardware turn off the skateboard. Then, remove the old fixed tape using a hairdryer and clean the deck.

Have you obtained yourself a new board? It"s currently time to take it the plastic off and also get all set to put your tight tape down.

Remember the a mistake throughout this phase will cost you somewhere in between $5 and also 20$.

*

Applying the tight Tape

Peel turn off the sticker indigenous the grip tape sheet.

Know where you"re gonna place it, so you don"t apply it off-centered.

Remember that, normally speaking, the nose of a skateboard is bigger and broader than the tail.

Now that you"ve peeled off the sticker, host the tight tape straight and also slowly reduced it towards the deck, laying it down as gently together possible.

The ultimate score is no to have any type of parts not extended with grip tape.

If needed, measure up the extra fixed tape ~ above both sides before you peel it turn off to have actually an idea of wherein to stick it.

Once you"ve to reduce the difficult grip, drop the palm of her hand on the center of the board and press the sheet down firmly.

The facility of the tight tape has actually been glued come the skateboard.

Now, it"s time to use both hands to apply the remaining part of the ice by gradually moving end the edges and also out towards the tail and nose.

This process will remove all the air balloon that could have formed.

*

Cutting the Excess fixed Tape

Time to reduced the excess.

Use an adjustable wrench - or any other heavy tool - come scrape the edges of the skateboard deck spanned with tight tape till you a white line.

Ideally, you need to scrape the off till you view the sticky part and the sandy grippy parts disappear.

By act so, it will certainly be less complicated to reduced the overfill with, because that instance, a energy knife or a razor. The much more you scrape it, the much easier it will certainly be to cut everything off.

Now, make some little cuts top top the edge to help you cut the overfill grip.

Hold the board stable with one hand and slowly reduced the tape around the deck.

Scrap the edges once again come get every little thing glued down.

One last tip: use the excess fixed tape come sand down the edges of the skateboard deck for a nice and smooth feel and avoid skin up.

See more: No Cell Wall Only Plasma Membrane And Cell Wall, Quiz 2: Cell Design Flashcards

The tight tape has actually been successfully used to her board. Now, you have the right to start mounting the trucks.