JavaScript is disabled. For a better endure, please allow JavaScript in your browser before proceeding.


You are watching: 2007 jeep compass camshaft position sensor location

I have a 2008 Jeep Patriot via a 2.4 liter engine, cannot find this sensor. Anyone understand where to uncover it?
*

-Todd08 Sport 4x4 FDI Silver, CRD Stu"s Coil Springs, Mud Flaps, Weathertech vent shades, TAG Rear BumperCarr Lightwing, Pilot Navigator Driving Lights, K&N Air Filter and also a jp.com decal :smiley_thumbs_up:
*

*

"Nothing is either excellent or poor, but thinking renders it so."- William Shakespeare"I swear to drunk I"m not God!"- Anonymous
Just had the same problem with the engine stuttering and also tractivity control/check engine light come on.I have some cost-free time, not so a lot complimentary money, so I am looking to do this myself. Can you assist straight me to the Power Transfer Unit Removal instructions? First time on the forum so please foroffer me I am a newbie!
*



See more: How Much Is 4 Cloves Of Garlic Is One Clove? How Much Garlic Is One Clove

Crankshaft Sensor replacementJust replaced my crankshaft sensor... excellent luck! Make sure you take off all the plastic components (engine cover, battery accessibility cover, and air filter box) and also disconnect the battery. I had actually one heck of a time locating it and might not reach it from underneath the vehicle. I was standing on a barstool on the driver"s side with fifty percent of my body dvery own inside the Jeep. I lastly found it after following the wires down the earlier of the engine by feeling my means dvery own. You can"t see the sensor or the bolt you need to take out to relocation it. The best way I can explain just how to get it out is to find the sensor by touch and place a 10mm deep well socket on the bolt (it is located over the sensor)then location a 12 inch extension onto that, and then you have the right to attach a ratchet to rerelocate the bolt. I couldn"t perform it with the entirety combination put together bereason I could only use one hand also, it"s a tight space. When I put it ago I had actually to put a tiny item of paper inside the socket to make the bolt continue to be in nice & snug bereason I couldn"t reach in to revolve the bolt with my fingers. I aobtain had actually to "build out" the relations one piece at a time. Put it all ago together and also reset the codes. The number 2 on the diagram is the location of the crankshaft sensor (looking at the engine from the driver"s side).