Six cylinder two wheel journey automatic 93,000 miles.

You are watching: 2004 hyundai santa fe 2.4 crankshaft position sensor location

where is the crankshaft sensor located on this car? ns cannot find it. Carry out I must remove the intake? I watch wires walk under the intake but cannot phone call what they room for.
*

The crankshaft sensor is situated at the former of the engine under at the time belt pulley. Friend will need to remove the time belt cover. Here is a chart to aid you see what i am talking about. The six. Right here is a guide that can provide you an ext information on the job:https://www.rebab.net/articles/crankshaft-angle-sensor-replacementHere is what it will certainly be favor (below) because that four and six cylinder engines.Please allow us know what happens.Cheers
*

*


ns looked for about an hour last night in this area and could not uncover it. Is that under something else or hidden? I have actually the new sensor and also know what that looks like, but cannot see it ~ above the car. I went to the Hyundai dealership and also asked a mechanic. The crankshaft sensor is over the starter ~ above the next of the block. A bit tough to acquire to, but I changed it and car is running again.

I want to locate the sensor, and also possibly check out the component number. Or if any kind of one knows just how to kindly help me?
The crankshaft sensor is in the side of the block, behind the exhaust manifold.
*
Part#391803E100 $74.27
Hey MUSA, The crankshaft position sensor is in the side of the block, behind the exhaust manifold.Here is a chart to assist you locate it:Please allow us understand what you uncover so it will help others.Best, Ken
four cylinder former wheel drive manual. Where is the crankshaft place sensor and also how long does it take to replace on a 2.4L?

*

*

Note:Part and labor may vary in ~ location.https://www.rebab.net/kpages/auto_repair_manuals_alldata.htm
mine 2004 Hyundai Santa Fe will not start. I already installed a new fuel pump and still same. I was thinking may be the crankshaft sensor but I execute not understand where that is. How deserve to I discover it?
You execute not change parts and also hope the it works. It is going to be costly and a garbage of time and money uneven you are exceptionally lucky.You have to start through diagnostics to find out what is lacking causing the non starting.
mine SUV suddenly would not transition into 2nd gear going down the highway. I babied it home and noticed also that placing that in turning back the engine instantly quit. Idle the car and also it is fine. Placing that in drive it jumps. So ns took out my computer examine tool and it said the crankshaft sensor to be bad.So i guess I require to understand where this is situated on the engine? Thanks, note
ns doubt the is her crank sensor, but here is location in picture. If it still go it have actually a infection professional check it. It may be a governor or in need of transmission rebuild.
factor I said the sensor is my tester offered me the p003 and said crankshaft position sensor. Someone told me that i would need to remove the timing belt cover and crankshaft pulley. Girlfriend are showing the sensor at the top of the engine?
Hello, On mine Car, we Were at A Stoplight around To revolve Left and The car Stalled Out. It would Not Start right Away, however After Pushing...
The car Starts and Runs around 10 Seconds and Then simply Stops, The Crankshaft Sensor and also Timing Belt Were changed At Shop critical Week, Could...

See more: Nose Piercing Bump: How Do I Know If My Nose Piercing Is Infected Nose Piercing


Is over there A Sensor that The computer Wants info From after The Engine has actually Been running For 3 Seconds?
My automobile Does not Switch Off straight Away and also I need to Stall The Engine To turn It Off. After ~ I turn The an essential To off The Engine does A...